Constructed of Heavy 7 gauge mild steel
Structural integrity is engineered for 25 years of operation. We also offer optional 1/4” construction for the heaviest of loads.
3-D Oscillating Manifold System
Combination of oscillating manifold, and stationary manifolds to clean your parts with 360 degree’s of coverage, This combination truly cleans 3-Dimensionally, spraying the entire exterior while penetrating all exposed crevices with multiple angles of cleaning power. Click here for more information
Midlevel removable spray bar
Swing away Mid level spray manifold for increased pressure on reduced height loads.
Rotating Turntable Gear Driven, Breaker Protected
Engineered to exceed service intervals, and failures associated with tire drive and chain driven systems. Click here for more information
Clamshell Style V-Notched Door for Safety
Safest design for operators loading and offloading parts using an overhead crane or forklift. Click here for more information
Slope Floor to Drain
False floor is designed to catch debris and direct soiled solution to removable stainless steel chip baskets for ease of maintenance and clean-out.
Debris Containment System
Designed to trap debris and sludge through removable stainless steel baskets prior to returning over main wash reservoir wall. Click here for more information
Turntable Jog
Push button turntable Jog rotates table for easy positioning when loading and offloading parts.
Door Safety Interlock
To Ensure safe operation, all Vortex Parts Washers are equipped with safety interlock switches. Washer pumps will not operate if door is open.
Wash Cycle Timer with Automatic Reset
Several options to choose from, including Eagle style programmable timer. Standard 60 minute timer.
Emergency Stop Button
Stops all mechanical operation, table drive and pumps.
Auto Water Fill and Low water Shut Off protection – protects pumps and heat system
Automatically maintains consistent water level within 1.5”, also turns off heaters in case of unsafe water level.
2 Channel, 24 hour 7 day programmable timer
Controls heat system and optional oil skimmer. Pre-heats tank prior to shift, runs oil skimmer during off hours.
Adjustable Temperature Control
Thermostat controls are microprocessor-based, panel mounted with digital readout.
Single or Dual Rear Mounted Wash Pump Strainers.
Removable screens to prevent debris from entering pumps prior to passing through to wash manifolds.
208, 230, 460 volt – 60 Hz 3 phase with 120V controls
Can custom build to meet any voltage requirements.
Solvent Free Operation, EPA – Eco-friendly
Closed loop design, detergent based operation.